General Wire Drain Cleaner Rsvd 2014 Cable Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          5 - 15 minutes            

Sections

2

• Front Assembly
• 3 steps
• Cable
• 2 steps

Flags

0

• BackGeneral Wire Drain Cleaner R-SV-D (2014)

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove the cable end cover               

• Turn off the drain cleaner and disconnect it from power before beginning any maintenance.
• Slide the rubber cable cover off of the end of the cable.

Turn off the drain cleaner and disconnect it from power before beginning any maintenance.

Slide the rubber cable cover off of the end of the cable.

1024

Step 2

              Loosen the front assembly screws               

• Use a flathead screwdriver to loosen the three screws around the edge of the front assembly.

Use a flathead screwdriver to loosen the three screws around the edge of the front assembly.

Step 3

              Remove the front assembly               

• Pull the front assembly off of the drain cleaner and slide it over the cable to remove it.
• During reassembly, make sure the three screws on the front assembly line up with the slots on both the metal cable container back and the plastic cable container.

Pull the front assembly off of the drain cleaner and slide it over the cable to remove it.

During reassembly, make sure the three screws on the front assembly line up with the slots on both the metal cable container back and the plastic cable container.

Step 4

              Remove the cable container               

• Slide the plastic cable container out of the metal container back.

Slide the plastic cable container out of the metal container back.

Step 5

              Remove the cable               

• Pull the cable out of the plastic cable container.
• During reassembly, make sure to insert the end of the cable with the hook (as shown in the third photo) first, then coil the rest of the cable into the container in a counter-clockwise fashion.

Pull the cable out of the plastic cable container.

During reassembly, make sure to insert the end of the cable with the hook (as shown in the third photo) first, then coil the rest of the cable into the container in a counter-clockwise fashion.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                    Adam O'Camb                     

Member since: 04/11/2015

173,479 Reputation

                                      418 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges