Difficulty

Very difficult

Steps

8

Time Required

                          1 hour

Sections

3

  • Bowl and Lid
  • 1 step
  • Base
  • 2 steps
  • Power Cord
  • 5 steps

Flags

0

  • BackHamilton Beach 70740

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bowl and Lid
  • Turn the bowl counterclockwise and lift.

Turn the bowl counterclockwise and lift.

1024

Step 2

              Base
  • Using a #2 Phillips head screwdriver, remove the two 11 mm screws from the base.
  • Pull suction cups straight out.

Using a #2 Phillips head screwdriver, remove the two 11 mm screws from the base.

Pull suction cups straight out.

Step 3

  • Remove rubber caps using the heavy duty spudger.
  • Remove the four 11 mm screws using the #2 Phillips head screwdriver.
  • Pull base straight out.

Remove rubber caps using the heavy duty spudger.

Remove the four 11 mm screws using the #2 Phillips head screwdriver.

Pull base straight out.

Step 4

              Power Cord
  • Using a #2 Phillips head screwdriver, remove the four 9 mm screws.
  • From the open base pull the motor straight out.

Using a #2 Phillips head screwdriver, remove the four 9 mm screws.

From the open base pull the motor straight out.

Step 5

  • Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor and then rewire the new power cord to the motor.

Using the wire stripper crimping tool cut the black wire connection from the power cord to the motor and then rewire the new power cord to the motor.

Step 6

  • Remove the two 12 mm screws using the #2 Phillips head screwdriver.
  • Remove plastic piece.

Remove the two 12 mm screws using the #2 Phillips head screwdriver.

Remove plastic piece.

Step 7

  • Remove the three 12 mm screws using the #2 Phillips head screwdriver.
  • Remove the plastic piece by pulling straight up.

Remove the three 12 mm screws using the #2 Phillips head screwdriver.

Remove the plastic piece by pulling straight up.

Step 8

  • Remove the power cord from the ground by removing the solder with the soldering tool.
  • Solder the new ground from the new power cord.

Remove the power cord from the ground by removing the solder with the soldering tool.

Solder the new ground from the new power cord.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Travis Williams

Member since: 02/02/2017

552 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 17-4, Blackwell Spring 2017                        

                                                  Member of USF Tampa, Team 17-4, Blackwell Spring 2017 



                    USFT-BLACKWELL-S17S17G4                     


                                            3 Members                     


                                            7 Guides authored