The Hamilton Beach 70740 two speed, 8 cup food processor released in 2010.
Student-Contributed Wiki
An awesome team of students from our education program made this wiki.
The food processor is switched to ON but there is no power.
Confirm that the processor is plugged into the outlet and outlet has power.
Check to see that the bowl and lid are locked in place by setting the bowl into the preset slots with the handle facing the right side of the processor. Then rotate the bowl clockwise until locked. If not the processor will not run.
If processor is plugged into a working outlet and bowl is locked into place but the unit is still not working, then the power cord may need to be replaced. Inspect the cord for any damages and if replacement is needed consult the replacement guidefor the power cord.
If the above does NOT apply and the processor is still not working, then the motor may be damaged. To replace the motor follow the replacement guide.
The blade is not effectively chopping food.
If the blade is dull there are two possible solutions. One is to sharpen the blade using a sharpening tool, however if you do not have access to a sharpening device simply replace the old blade.
The blades are not spinning even though the processor is running.
The blade may NOT be spinning if it is NOT securely locked onto the main shaft of the processor. Make sure it is locked before turning the processor on.
The blade may begin to slow down or completely stop. If this occurs clean out bowl and clean off blade thoroughly. Also use smaller portions of food in the food processor to help prevent any build up.
The blades may not be spinning because the gears that run the shaft have been broken or stripped. If the motor can be heard running but the blades are not spinning then the gears may need to be replaced. If this is the case please consult the replacement guide for gears.
The blades may not be spinning because the motor is damaged. If the processor is plugged in correctly and the motor is not making any noise or spinning the blades properly then the motor may need to be replaced. If this is the case follow the steps in the replacement guide.
Switch is unresponsive.
Make sure that the processor is plugged correctly into a working outlet.
If the processor’s switch is unresponsive in one or multiple modes then the switch may be bad and need to be replaced. Follow the replacement guidefor the processors switch. It is helpful to keep this area free of liquids and food to prevent it from going bad.
Where can Hamilton Beach parts be purchased?
The Hamilton Beach website sells most of the parts to their products, but if a specific component cannot be found on their website consider looking in a local appliance store that may have the part you need.
