Difficulty

Moderate

Steps

4

Time Required

                          8 minutes

Sections

2

  • Handset
  • 3 steps
  • Handset Microphone
  • 1 step

Flags

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSony SPP-A946

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Handset
  • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.
  • Product is made of brittle plastic.

After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

Product is made of brittle plastic.

1024

Step 2

  • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.
  • The opening should become bigger if you exert force at a 30 degrees angle.
  • Increase the degree of slant until the back cover is completely removed.

Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

The opening should become bigger if you exert force at a 30 degrees angle.

Increase the degree of slant until the back cover is completely removed.

Step 3

  • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.
  • Use a screwdriver to remove all 3 screws.

After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

Use a screwdriver to remove all 3 screws.

Step 4

              Handset Microphone
  • After disassembling the handset, you will see the inner components of the handset.
  • Locate the rubber part towards the very bottom of the handset. This is the microphone with protective rubber cover.
  • Remove the protective rubber cover. This may require a spudger.
  • The microphone is exposed upon removal of the protective rubber cover. Avoid contact with water.

After disassembling the handset, you will see the inner components of the handset.

Locate the rubber part towards the very bottom of the handset. This is the microphone with protective rubber cover.

Remove the protective rubber cover. This may require a spudger.

The microphone is exposed upon removal of the protective rubber cover. Avoid contact with water.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Han Shih

Member since: 09/29/2016

343 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       IUPUI, Team 3-3, Harley Fall 2016                        

                                                  Member of IUPUI, Team 3-3, Harley Fall 2016 



                    IUPUI-HARLEY-F16S3G3                     


                                            4 Members                     


                                            17 Guides authored