Difficulty

Easy

Steps

5

Time Required

                          5 minutes

Sections

2

  • Battery
  • 3 steps
  • RAM
  • 2 steps

Flags

0

  • BackHannspree SN12E2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Unplug and power off your laptop.

Unplug and power off your laptop.

1024

Step 2

  • Close your laptop .
  • Place your laptop face down on a flat surface.

Close your laptop .

Place your laptop face down on a flat surface.

Step 3

  • Unlatch the lock on the top right of your laptop first.
  • You will need to pull on the lock on the left side and remove the battery at the same time
  • The left lock is a spring lock and needs constant pressure applied in order to stay open.

Unlatch the lock on the top right of your laptop first.

You will need to pull on the lock on the left side and remove the battery at the same time

The left lock is a spring lock and needs constant pressure applied in order to stay open.

Step 4

              RAM
  • Remove the RAM access door.
  • Remove the two 3mm screws using a Phillips #0 screwdriver.
  • Gently lift on the door out of place.
  • When replacing the door it should click into place. Ensure the alignment tabs are correctly seated and gently push until it clicks into place.

Remove the RAM access door.

Remove the two 3mm screws using a Phillips #0 screwdriver.

Gently lift on the door out of place.

When replacing the door it should click into place. Ensure the alignment tabs are correctly seated and gently push until it clicks into place.

Step 5

  • Gently push outward on the two retaining clips, being careful not to damage the motherboard.
  • Lift up on the RAM until it makes a 35 degree angle with the board.
  • Remove the RAM by pulling away from the housing at 35 degrees.

Gently push outward on the two retaining clips, being careful not to damage the motherboard.

Lift up on the RAM until it makes a 35 degree angle with the board.

Remove the RAM by pulling away from the housing at 35 degrees.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Tim Chase

Member since: 03/25/2019

357 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team S2-G2, Simcock Spring 2019                        

                                                  Member of UMass Dartmouth, Team S2-G2, Simcock Spring 2019 



                    UMASSD-SIMCOCK-S19S2G2                     


                                            4 Members                     


                                            9 Guides authored