Difficulty
Difficult
Steps
6
Time Required
10 - 20 minutes
Sections
1
- Havoc Heli IR LED
- 6 steps
Flags
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
BackToy
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Havoc Heli IR LED
- Power off the controller before disassembly.
- Place a small piece of tape over the Light button to prevent it from falling out in later steps.
- Flip the controller over so the back is facing up.
Power off the controller before disassembly.
Place a small piece of tape over the Light button to prevent it from falling out in later steps.
Flip the controller over so the back is facing up.
1024
Step 2
- Remove the battery compartment screw with a small Phillips screw driver.
- Lift off the battery cover.
- Remove the six AA batteries from the compartment.
Remove the battery compartment screw with a small Phillips screw driver.
Lift off the battery cover.
Remove the six AA batteries from the compartment.
Step 3
- Remove the remaining four screws with a small Phillips screw driver.
- Flip the device over so the front is facing up.
- Remove the front cover and place it to the left side.
- Make sure to note the locations of the joysticks and other controls in case they fall out of place during this or future steps.
Remove the remaining four screws with a small Phillips screw driver.
Flip the device over so the front is facing up.
Remove the front cover and place it to the left side.
Make sure to note the locations of the joysticks and other controls in case they fall out of place during this or future steps.
Step 4
- Lift up the red IR LED cover to remove it.
Lift up the red IR LED cover to remove it.
Step 5
- Use the soldering iron and solder wick to remove the solder from the IR LED you’re replacing.
- Pull the LED out through the top.
Use the soldering iron and solder wick to remove the solder from the IR LED you’re replacing.
Pull the LED out through the top.
Step 6
- Insert the new LED into the slot.
- Make sure that the short lead of the LED is on the right.
- Use the soldering iron and solder to connect the new LED.
Insert the new LED into the slot.
Make sure that the short lead of the LED is on the right.
Use the soldering iron and solder to connect the new LED.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Michael Kent
Member since: 03/30/2016
128 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
Michigan Tech, Team 1-13, Lauer Fall 2016
Member of Michigan Tech, Team 1-13, Lauer Fall 2016
MTU-LAUER-F16S1G13
1 Member
1 Guide authored
