Difficulty
Moderate
Steps
4
Time Required
10 minutes
Sections
2
- Rear Case
- 2 steps
- Camera
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackHKC P776A
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Separating Digitizer and Case
- Insert the plastic opening tool between the digitizer and the case.
- Place the spudger in the gap created by the plastic opening tool to assist in separation.
Insert the plastic opening tool between the digitizer and the case.
Place the spudger in the gap created by the plastic opening tool to assist in separation.
1024
Step 2
- Slide the spudger along the perimeter of the device to fully separate the two pieces.
Slide the spudger along the perimeter of the device to fully separate the two pieces.
Step 3
Removing the Cable from the Moatherboard
- Use the tip of the spudger to release the latches on the motherboard.
Use the tip of the spudger to release the latches on the motherboard.
Step 4
- Remove the camera from the device.
Remove the camera from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Ryan Gornati
Member since: 01/22/2015
409 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team 7-6, Remmell Winter 2015
Member of USF Tampa, Team 7-6, Remmell Winter 2015
USFT-REMMELL-W15S7G6
3 Members
14 Guides authored
