Difficulty
Moderate
Steps
4
Time Required
10 - 15 minutes
Sections
2
- Case
- 2 steps
- Fan Blades
- 2 steps
Flags
0
BackHoneywell HT-216E
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Case
- Before you begin, be sure to unplug the fan.
- Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.
Before you begin, be sure to unplug the fan.
Remove the four 14 mm screws from the back of the device using the Phillips #0 Screwdriver.
1024
Step 2
- Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.
Pull the front and back parts of the case away from each other until the back is free from the front. This may require a large amount of force.
Step 3
Fan Blades
- Remove the hex nut from the fan motor with a 10mm hexagonal ratcheting socket wrench.
- The nut uses a left-handed thread.
Remove the hex nut from the fan motor with a 10mm hexagonal ratcheting socket wrench.
The nut uses a left-handed thread.
Step 4
- Grasp the fan blade firmly and pull upward to remove it from the center column of the fan.
- The slots on the fan blades and center column need to be aligned for reassembly.
Grasp the fan blade firmly and pull upward to remove it from the center column of the fan.
The slots on the fan blades and center column need to be aligned for reassembly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Jenna Johnson
Member since: 10/14/2014
247 Reputation
1 Guide authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 10-40, Amido Fall 2014
Member of Cal Poly, Team 10-40, Amido Fall 2014
CPSU-AMIDO-F14S10G40
3 Members
7 Guides authored
