Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes

Sections

1

  • Replace The Motor
  • 6 steps

Flags

0

  • BackHoover LiNX

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Replace The Motor
  • Detach the rolling assembly from the body by pushing the button found at the base.

Detach the rolling assembly from the body by pushing the button found at the base.

1024

Step 2

  • Remove the seven 7.5mm Phillips #1 screws from the brush retainer.

Remove the seven 7.5mm Phillips #1 screws from the brush retainer.

Step 3

  • Remove the brush and retainer from the rolling assembly.
  • The brush will need to be disconnected from the belt.

Remove the brush and retainer from the rolling assembly.

The brush will need to be disconnected from the belt.

Step 4

  • Remove the eight 4mm Phillips #1 screws from the bottom panel.

Remove the eight 4mm Phillips #1 screws from the bottom panel.

Step 5

  • Remove the bottom panel.

Remove the bottom panel.

Step 6

  • Remove the motor.

Remove the motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors 


                    Sara Vlhova

Member since: 01/25/2018

541 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team S7-G4, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S7-G4, Passmore Spring 2018 



                    USFT-PASSMORE-S18S7G4                     


                                            4 Members                     


                                            12 Guides authored

Brian - May 2, 2020

Reply

Where does one get a new brush motor?

Paulie Jeanne - Feb 21, 2022

Reply

Thank you for the photos! They’ve been helpful as I’m putting my Linx back together and can’t quite remember how the wires go back in the nozzle assembly. When putting the top plate back on, it’s a very tight fit where the top will be pushed up if maligned.

In the elbow part- It looks like the positive lead is on the left in your photo, but it would be helpful if you would add that specification to your step.

Great Job!