Difficulty
Easy
Steps
9
Time Required
10 minutes
Sections
2
- Hoover LiNX Handle Teardown
- 6 steps
- The Motherboard Inside The Handle
- 3 steps
Flags
0
BackHoover LiNX
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Hoover LiNX Handle Teardown
- Remove the single 15mm Phillips #1 screw from the handle.
Remove the single 15mm Phillips #1 screw from the handle.
1024
Step 2
- Remove the handle by pulling it up.
Remove the handle by pulling it up.
Step 3
- Remove two 15mm Phillips #1 screws from the handle.
Remove two 15mm Phillips #1 screws from the handle.
Step 4
- Use a plastic opening tool to carefully pry the black cover off of the handle.
Use a plastic opening tool to carefully pry the black cover off of the handle.
Step 5
- Remove five 15mm Phillips #1 black screws from the handle.
Remove five 15mm Phillips #1 black screws from the handle.
Step 6
- Remove the silver plastic cover using the plastic opening tool.
Remove the silver plastic cover using the plastic opening tool.
Step 7
The Motherboard Inside The Handle
- Remove the black rubber cover from the motherboard.
Remove the black rubber cover from the motherboard.
Step 8
- Remove two 8mm Phillips #1 screws from the motherboard.
Remove two 8mm Phillips #1 screws from the motherboard.
Step 9
- Carefully pull the motherboard out with its attached wires.
Carefully pull the motherboard out with its attached wires.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Sara Vlhova
Member since: 01/25/2018
541 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S7-G4, Passmore Spring 2018
Member of USF Tampa, Team S7-G4, Passmore Spring 2018
USFT-PASSMORE-S18S7G4
4 Members
12 Guides authored
