Hoover Presto 2 In 1 Cordless Stick Belt Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Belt
8 steps

Flags

BackHoover Presto 2-in-1 Cordless Stick
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Belt

Press grey release button on stick vacuum to release vacuum head.

Press grey release button on stick vacuum to release vacuum head.

1024

Step 2

Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head
Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the “locked” symbol to the “unlocked” symbol

Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head

Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the “locked” symbol to the “unlocked” symbol

Step 3

Flip the vacuum head over so that the wheels and screws are facing you.
Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.

Flip the vacuum head over so that the wheels and screws are facing you.

Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.

Step 4

Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out.
Remove the two 15mm screws located underneath the wheels with a PH #1 screw driver.

Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out.

Remove the two 15mm screws located underneath the wheels with a PH #1 screw driver.

Step 5

Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated

Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated

Step 6

Remove the mechanism with your hands.

Remove the mechanism with your hands.

Step 7

Remove the two 7mm screws located on either side of the roller with a PH #1 screw driver.
Removing these screws helps loosen the belt so that it is easier to take off the mechanism.

Remove the two 7mm screws located on either side of the roller with a PH #1 screw driver.

Removing these screws helps loosen the belt so that it is easier to take off the mechanism.

Step 8

Use a metal spudger to lift the belt away from the mechanism.

Use a metal spudger to lift the belt away from the mechanism.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    katia zubieta

Member since: 09/11/2017

422 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       CSU Fullerton, Team S2-G6, Bruce Fall 2017                        

                                                  Member of CSU Fullerton, Team S2-G6, Bruce Fall 2017 



                    CSUF-BRUCE-F17S2G6                     


                                            3 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team