Difficulty
Easy
Steps
5
Time Required
10 minutes
Sections
1
- Brush
- 5 steps
Flags
0
BackHoover T-Series WindTunnel Pet UH30310
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Brush
- Place the vacuum on its back.
- On the bottom right side, push the red lever to the left.
- Remove the plastic cover.
Place the vacuum on its back.
On the bottom right side, push the red lever to the left.
Remove the plastic cover.
1024
Step 2
- Grab the red switch under the brush and push left.
- Then remove the plastic base plate.
Grab the red switch under the brush and push left.
Then remove the plastic base plate.
Step 3
- Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.
Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.
Step 4
- Remove the two screws on the left side of the brush.
Remove the two screws on the left side of the brush.
Step 5
- Pull the clear plastic away from the head of the vacuum.
- Slide the belt off the metal rod with your finger.
- Pull the brush free.
Pull the clear plastic away from the head of the vacuum.
Slide the belt off the metal rod with your finger.
Pull the brush free.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Erik Ingels
Member since: 01/18/2018
193 Reputation
2 Guides authored
Badges:
2
Team
Cal Poly, Team S12-G4, Banghart Winter 2018
Member of Cal Poly, Team S12-G4, Banghart Winter 2018
CPSU-BANGHART-W18S12G4
5 Members
9 Guides authored
