Difficulty

Easy

Steps

5

Time Required

                          20 minutes

Sections

1

  • Push Button
  • 5 steps

Flags

0

  • BackMicrosoft Game Console Accessory

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What is needed to replace the fight stick buttons is a Sanwa 30 or 24 mm push button and a Phillips head screwdriver to remove the screws found in this fight stick.

Before you begin if you need to fix the opt right button a 24mm push button is needed but if it is for the 8 buttons, you need the 30mm Sanwa buttons.

What you need

Step 1

              Push Button
  • Flip your Fight Stick so the bottom is facing up.
  • Remove the sticker covering the screw in the bottom middle of the device.
  • Remove eight screws from the bottom of the device using a Phillips #0 screwdriver.

Flip your Fight Stick so the bottom is facing up.

Remove the sticker covering the screw in the bottom middle of the device.

Remove eight screws from the bottom of the device using a Phillips #0 screwdriver.

1024

Step 2

  • Find the storage compartment that holds the USB wire.
  • Open the case by putting your hand in the compartment and pushing up.
  • Put your Fight Stick on its side to make the other steps easier.

Find the storage compartment that holds the USB wire.

Open the case by putting your hand in the compartment and pushing up.

Put your Fight Stick on its side to make the other steps easier.

Step 3

  • Use your fingers to pull the black grip to detach both wires connected to the pushbutton.
  • Pulling the wire instead of the black grip can cause the wires to not function.

Use your fingers to pull the black grip to detach both wires connected to the pushbutton.

Pulling the wire instead of the black grip can cause the wires to not function.

Step 4

  • Twist the button you are planning to remove.
  • The tabs must be on its side as shown in the second picture so it is easier to grab in the next step.

Twist the button you are planning to remove.

The tabs must be on its side as shown in the second picture so it is easier to grab in the next step.

Step 5

  • Squeeze the tabs in the button.
  • While squeezing, push the button inward, so it falls out.

Squeeze the tabs in the button.

While squeezing, push the button inward, so it falls out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    gabriel garcia

Member since: 01/24/2022

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       CSU Los Angeles, Team 21-17, Briggs Spring 2022                        

                                                  Member of CSU Los Angeles, Team 21-17, Briggs Spring 2022 



                    CSULA-BRIGGS-S22S21G17                     


                                            1 Member                     


                                            1 Guide authored