Difficulty

Moderate

Steps

7

Time Required

                          15 - 25 minutes

Sections

2

  • Hover-1 Chrome Disassembly
  • 3 steps
  • Outer Shell
  • 4 steps

Flags

0

  • BackHover-1 Chrome

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Hover-1 Chrome Disassembly
  • Flip the Hover-1 Chrome upside down.
  • Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.
  • Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

Flip the Hover-1 Chrome upside down.

Use a Phillips #2 screwdriver to remove the fourteen 14 mm screws from the bottom of the Hover-1.

Break the two black tape circles, and remove the two 15 mm Phillips screws underneath.

1024

Step 2

  • Lift the shell without the speaker grille and unplug the battery.

Lift the shell without the speaker grille and unplug the battery.

Step 3

  • Lift the shell with the speaker grille.
  • Unplug the speaker.
  • Unplug the LEDs.
  • Unplug the power button
  • Unplug the charging port.

Lift the shell with the speaker grille.

Unplug the speaker.

Unplug the LEDs.

Unplug the power button

Unplug the charging port.

Step 4

              Outer Shell
  • Remove the twelve 14 mm Phillips #2 screws holding the top shell on.
  • The other six screws are on the side without the battery.

Remove the twelve 14 mm Phillips #2 screws holding the top shell on.

The other six screws are on the side without the battery.

Step 5

  • Free the cables held atop the bracket holding the battery in place.
  • Remove the four 14 mm Phillips #2 screws holding the battery bracket in place.
  • Pull the battery bracket free.

Free the cables held atop the bracket holding the battery in place.

Remove the four 14 mm Phillips #2 screws holding the battery bracket in place.

Pull the battery bracket free.

Step 6

  • Unplug the cords for the top LEDs.
  • The other side of the board is structurally symmetrical. However instead of going under the battery bracket, these cords go through a zip tie. These cables must be removed from the zip tie in order to continue.

Unplug the cords for the top LEDs.

The other side of the board is structurally symmetrical. However instead of going under the battery bracket, these cords go through a zip tie. These cables must be removed from the zip tie in order to continue.

Step 7

  • Turn the board over and pull the top panel off.

Turn the board over and pull the top panel off.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Dylan Prins

Member since: 10/08/2018

212 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team S4-G1, White Fall 2018                        

                                                  Member of Cal Poly, Team S4-G1, White Fall 2018 



                    CPSU-WHITE-F18S4G1                     


                                            4 Members                     


                                            6 Guides authored