Hover 1 H1 Power Button Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

Bottom Shell
4 steps
Power Button
3 steps

Flags

BackHover-1 H1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Bottom Shell

Remove the ten 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.
Remove the twelve 9mm sheet metal screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

Remove the ten 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

Remove the twelve 9mm sheet metal screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

1024

Step 2

Puncture the two black stickers by using the tip of a screwdriver.
Remove the two 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

Puncture the two black stickers by using the tip of a screwdriver.

Remove the two 9mm machine screws by using a long Phillips #2 screwdriver to rotate the screws counterclockwise.

Step 3

Lift each side of the bottom shell by pulling up.
When lifting the shell, take care to not tear any cables from their connectors.

Lift each side of the bottom shell by pulling up.

When lifting the shell, take care to not tear any cables from their connectors.

Step 4

Unplug the battery by pulling gently on both sides of the orange connector.

Unplug the battery by pulling gently on both sides of the orange connector.

Step 5

              Power Button

Unplug the power button connector by pinching the tab on the front and pulling directly upwards.
Pull the cable through the center section of the hoverboard.
For reassembly, you will have to feed the cable back through the center section. This can be done using a rigid wire or cable.

Unplug the power button connector by pinching the tab on the front and pulling directly upwards.

Pull the cable through the center section of the hoverboard.

For reassembly, you will have to feed the cable back through the center section. This can be done using a rigid wire or cable.

Step 6

Using an adjustable wrench, remove the nut on the back of the power button by rotating the nut counterclockwise.

Using an adjustable wrench, remove the nut on the back of the power button by rotating the nut counterclockwise.

Step 7

Pull the power button through the hole in the shell.

Pull the power button through the hole in the shell.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Christopher Bruni

Member since: 10/08/2018

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Cal Poly, Team S17-G6, White Fall 2018                        

                                                  Member of Cal Poly, Team S17-G6, White Fall 2018 



                    CPSU-WHITE-F18S17G6                     


                                            4 Members                     


                                            7 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team