Hover 1 Maverick Central Bearing Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          20 minutes            

Sections

1

• Central Bearing
• 5 steps

Flags

0

• BackHover-1 Maverick

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Central Bearing               

• Remove the twenty 15mm Phillips #1 screws from the shell of the hoverboard.
• Remove the shell from the hoverboard. The central bearing is located in the center.

Remove the twenty 15mm Phillips #1 screws from the shell of the hoverboard.

Remove the shell from the hoverboard. The central bearing is located in the center.

1024

Step 2

• Unscrew the eight 16mm Phillips #1 screws holding the central bearing in place.

Unscrew the eight 16mm Phillips #1 screws holding the central bearing in place.

Step 3

• Unplug the wires that run through the central bearing. There is a black and yellow one that attaches to the battery and a set of white ones that attach to the motherboard.
• Run these wires out through the other end of the central bearing.

Unplug the wires that run through the central bearing. There is a black and yellow one that attaches to the battery and a set of white ones that attach to the motherboard.

Run these wires out through the other end of the central bearing.

Step 4

• One side of the bearing is easy to pop out with your hands.
• The other side of the bearing has wiring for the LED light running under it, so it cannot be pulled out with your hands. To get leverage, carefully use the metal spudger to wedge out this other side.

One side of the bearing is easy to pop out with your hands.

The other side of the bearing has wiring for the LED light running under it, so it cannot be pulled out with your hands. To get leverage, carefully use the metal spudger to wedge out this other side.

Step 5

• Take the central bearing out of the board.

Take the central bearing out of the board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Piper Feldman                     

Member since: 01/23/2020

391 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Cal Poly, Team S2-G2, White Winter 2020                        

                                                  Member of Cal Poly, Team S2-G2, White Winter 2020 



                    CPSU-WHITE-W20S2G2                     


                                            2 Members                     


                                            4 Guides authored