Difficulty

Easy

Steps

7

Time Required

                          5 - 10 minutes

Sections

2

  • Bottom Right Panel
  • 3 steps
  • Battery
  • 4 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackHover-1 Titan

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Right Panel
  • Flip the hoverboard so the bottom is facing up.
  • The right side is the side that has the power button. There is also an “R” on the metal plate underneath the battery.

Flip the hoverboard so the bottom is facing up.

The right side is the side that has the power button. There is also an “R” on the metal plate underneath the battery.

1024

Step 2

  • Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
  • Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
  • Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.

Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.

Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.

Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.

Step 3

  • Grip the bottom right panel and lift to remove it.

Grip the bottom right panel and lift to remove it.

Step 4

              Battery
  • Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.

Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.

Step 5

  • Remove the bundle of wires from the clip on the top of the battery.

Remove the bundle of wires from the clip on the top of the battery.

Step 6

  • Using a Phillips #1 screwdriver, remove the four 14 mm screws that hold the battery on the device.

Using a Phillips #1 screwdriver, remove the four 14 mm screws that hold the battery on the device.

Step 7

  • Remove the battery out of the hoverboard by lifting the battery then sliding it out from under the wires.

Remove the battery out of the hoverboard by lifting the battery then sliding it out from under the wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Jessica Ouyang

Member since: 10/08/2018

604 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team S15-G4, White Fall 2018                        

                                                  Member of Cal Poly, Team S15-G4, White Fall 2018 



                    CPSU-WHITE-F18S15G4                     


                                            4 Members                     


                                            10 Guides authored