Difficulty

Easy

Steps

7

Time Required

                          5 - 10 minutes

Sections

2

  • Bottom Right Panel
  • 3 steps
  • Power Button
  • 4 steps

Flags

0

  • BackHover-1 Titan

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Right Panel
  • Flip the hoverboard so the bottom is facing up.
  • The right side is the side that has the power button. There is also an “R” on the metal plate underneath the battery.

Flip the hoverboard so the bottom is facing up.

The right side is the side that has the power button. There is also an “R” on the metal plate underneath the battery.

1024

Step 2

  • Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
  • Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
  • Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.

Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.

Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.

Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.

Step 3

  • Grip the bottom right panel and lift to remove it.

Grip the bottom right panel and lift to remove it.

Step 4

              Power Button
  • Disconnect the battery by holding the yellow connectors and pulling apart.

Disconnect the battery by holding the yellow connectors and pulling apart.

Step 5

  • Unplug the red and black power button connector on the motherboard by squeezing the connector and pulling away from the board.
  • You can also unplug the light connector to free up your work space.

Unplug the red and black power button connector on the motherboard by squeezing the connector and pulling away from the board.

You can also unplug the light connector to free up your work space.

Step 6

  • Use an adjustable wrench to remove the 14 mm nut holding the button in the shell.

Use an adjustable wrench to remove the 14 mm nut holding the button in the shell.

Step 7

  • Pull the power button out of the panel.
  • Replace the power button.

Pull the power button out of the panel.

Replace the power button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Alexander Pham

Member since: 10/07/2018

221 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team S15-G4, White Fall 2018                        

                                                  Member of Cal Poly, Team S15-G4, White Fall 2018 



                    CPSU-WHITE-F18S15G4                     


                                            4 Members                     


                                            10 Guides authored