Difficulty
Easy
Steps
4
Time Required
15 - 20 minutes
Sections
1
- Charging Port
- 4 steps
Flags
0
BackHover-1 Ultra
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Charging Port
- Orient the hoverboard so that the pads are facing down.
- With the Phillips #1 screwdriver, remove all 18 of the screws on the underside of the board.
- Carefully remove the shell, lifting directly up.
Orient the hoverboard so that the pads are facing down.
With the Phillips #1 screwdriver, remove all 18 of the screws on the underside of the board.
Carefully remove the shell, lifting directly up.
1024
Step 2
- Using your hands or a crescent wrench, begin removing the charging port.
- Turn the charging port counter-clockwise to release it from the shell.
Using your hands or a crescent wrench, begin removing the charging port.
Turn the charging port counter-clockwise to release it from the shell.
Step 3
- Unclip the insulated red and black wires attached to the port from the motherboard
Unclip the insulated red and black wires attached to the port from the motherboard
Step 4
- Remove the charging port through the assembly.
- Place new charging port through the assembly.
- Clip red and black insulated wires into the motherboard.
Remove the charging port through the assembly.
Place new charging port through the assembly.
Clip red and black insulated wires into the motherboard.
To reassemble your device, follow the instructions for step 1 in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Camron Clifton
Member since: 10/22/2018
370 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
UC Davis, Team S7-G5, Lore Fall 2018
Member of UC Davis, Team S7-G5, Lore Fall 2018
UCD-LORE-F18S7G5
3 Members
3 Guides authored