Difficulty
Moderate
Steps
3
Time Required
5 - 10 minutes
Sections
1
- Ignition
- 3 steps
Flags
0
BackHover-1 XLS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Ignition
- Remove the six 16mm #3 Hex head screws located on the front panel.
- The screws are held in with Teflon tape, so use a chemical remover like B’laster to loosen the screws.
Remove the six 16mm #3 Hex head screws located on the front panel.
The screws are held in with Teflon tape, so use a chemical remover like B’laster to loosen the screws.
1024
Step 2
- Grab the front panel and gently lift it up to the side.
- The front panel is connected to the ignition, so don’t pull too hard or the wires will get damaged.
Grab the front panel and gently lift it up to the side.
The front panel is connected to the ignition, so don’t pull too hard or the wires will get damaged.
Step 3
- Remove the two, 19 mm Phillips #2 screws holding the ignition.
- Remove the yellow and red wires that are connected to the ignition. To remove them, look at the soldering guide provided by iFixit.
Remove the two, 19 mm Phillips #2 screws holding the ignition.
Remove the yellow and red wires that are connected to the ignition. To remove them, look at the soldering guide provided by iFixit.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Jonathan Hidalgo
Member since: 01/24/2019
575 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team S1-G2, White Winter 2019
Member of Cal Poly, Team S1-G2, White Winter 2019
CPSU-WHITE-W19S1G2
3 Members
6 Guides authored
