Difficulty
Very easy
Steps
7
Time Required
15 minutes
Sections
1
- How to Clean and Maintain a Rogers Champion Plus Universal Remote Control 2125BC0-BX
- 7 steps
Flags
0
BackRemote Control
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
How to Clean and Maintain a Rogers Champion Plus Universal Remote Control 2125BC0-BX
- Remove the battery cover and batteries from the remote.
Remove the battery cover and batteries from the remote.
1024
Step 2
- Use a Phillips #00 screwdriver to remove the two 2 mm screws on the bottom of the remote.
Use a Phillips #00 screwdriver to remove the two 2 mm screws on the bottom of the remote.
Step 3
- Insert a spudger into one of the two cavities on the back of the remote.
- Use the spudger to twist & pry until the seam of the remote separates.
- Use gentle movements to pry the seam, as if handled improperly can result in damage.
Insert a spudger into one of the two cavities on the back of the remote.
Use the spudger to twist & pry until the seam of the remote separates.
Use gentle movements to pry the seam, as if handled improperly can result in damage.
Step 4
- Run a spudger along the seam of the remote to widen the space between the top & bottom halves of the remote.
- Press firmly into the seam and listen for a popping sound, which indicate the seams have separated.
- Repeat for both sides of the remote.
- Return to the back of the remote and use the spudger to pop the remote open.
- Use gentle movements to pry the seam, as if handled improperly can result in damage.
Run a spudger along the seam of the remote to widen the space between the top & bottom halves of the remote.
Press firmly into the seam and listen for a popping sound, which indicate the seams have separated.
Repeat for both sides of the remote.
Return to the back of the remote and use the spudger to pop the remote open.
Step 5
- Remove the rubber number pad and the plastic divider below to reveal the circuit board.
- Use a cotton swab soaked in rubbing alcohol to clean the exposed circuit board.
- Try to clean using circular motions. Also, you can clean the affected area directly and not necessarily the whole board.
Remove the rubber number pad and the plastic divider below to reveal the circuit board.
Use a cotton swab soaked in rubbing alcohol to clean the exposed circuit board.
Try to clean using circular motions. Also, you can clean the affected area directly and not necessarily the whole board.
Step 6
- Clean the rubber number pad by dipping the toothbrush in rubbing alcohol and gently scrubing the back of the rubber keypad.
- Try to clean using circular motions.
Clean the rubber number pad by dipping the toothbrush in rubbing alcohol and gently scrubing the back of the rubber keypad.
Try to clean using circular motions.
Step 7
- If you need to replace the circuit board for any reason, it comes off by hand like the other components in this model of remote.
If you need to replace the circuit board for any reason, it comes off by hand like the other components in this model of remote.
Repeat the steps backwards to reassemble device.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Mohamad Mohamad
Member since: 01/18/2021
145 Reputation
1 Guide authored
Badges:
3
Team
York University, Team S1-G18, O'Regan Winter 2021
Member of York University, Team S1-G18, O'Regan Winter 2021
YORK-O'REGAN-W21S1G18
1 Member
1 Guide authored
