Difficulty
Moderate
Steps
13
Time Required
25 minutes
Sections
3
- Battery
- 5 steps
- Fan
- 4 steps
- How to clean the CPU fan on Asus VivoBook Q200E-BHI3T45
- 4 steps
Flags
0
BackAsus VivoBook Q200E-BHI3T45
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).
Use a Phillips 0 screwdriver to remove nine Phillips screws from the back of the laptop (four 7mm from the top hinge, four 5mm from the bottom hinge, and one 10mm screw from the center).
1024
Step 2
- Use a plastic opening tool to pry the back panel off.
Use a plastic opening tool to pry the back panel off.
Step 3
- Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.
Use a Phillips 0 screwdriver to remove the eight 5mm Phillips screws holding the battery in place.
Step 4
- Remove the ribbon cable with a pair of tweezers.
Remove the ribbon cable with a pair of tweezers.
Step 5
- Lift and remove the battery.
Lift and remove the battery.
Step 6
Fan
- Gently peel off the tape from the fan.
Gently peel off the tape from the fan.
Step 7
- Remove five 5mm screws using a Phillips 0 screwdriver.
- Remove the two 2mm screws with a Phillips 000 screwdriver.
Remove five 5mm screws using a Phillips 0 screwdriver.
Remove the two 2mm screws with a Phillips 000 screwdriver.
Step 8
- Disconnect the fan’s power cable by pulling upward on the pin connector with a pair of tweezers.
Disconnect the fan’s power cable by pulling upward on the pin connector with a pair of tweezers.
Step 9
- Grab the sides of the fan assembly and remove it by lifting upwards.
Grab the sides of the fan assembly and remove it by lifting upwards.
Step 10
How to clean the CPU fan on Asus VivoBook Q200E-BHI3T45
- Remove the tape connected to the fan covering plate.
Remove the tape connected to the fan covering plate.
Step 11
- Gently pull the covering plate from the covering tab.
Gently pull the covering plate from the covering tab.
Step 12
- Remove the covering plate.
Remove the covering plate.
Step 13
- From the back, push the fan out of the motor.
- Clean the fan using a damp cloth, and allow to dry.
From the back, push the fan out of the motor.
Clean the fan using a damp cloth, and allow to dry.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Bryann Tan
Member since: 09/25/2016
838 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 16-2, Eyestone Fall 2016
Member of USF Tampa, Team 16-2, Eyestone Fall 2016
USFT-EYESTONE-F16S16G2
3 Members
6 Guides authored