Difficulty

Easy

Steps

8

Time Required

                          20 minutes

Sections

1

  • How to Fix Sticky Controls on a Logitech RumblePad2
  • 8 steps

Flags

0

  • BackLogitech RumblePad2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              How to Fix Sticky Controls on a Logitech RumblePad2
  • Remove the battery pack cover.
  • Remove the batteries.

Remove the battery pack cover.

Remove the batteries.

1024

Step 2

  • Remove the five screws from the back of the controller using the #0 Phillips screwdriver.

Remove the five screws from the back of the controller using the #0 Phillips screwdriver.

Step 3

  • Remove the back panel from the controller.
  • It is easiest to first pry off the panel from the bottom, as shown in the pictures.
  • If using a tool to pry the panel off, do not insert the tool far into the controller. This may damage the motherboard.

Remove the back panel from the controller.

It is easiest to first pry off the panel from the bottom, as shown in the pictures.

If using a tool to pry the panel off, do not insert the tool far into the controller. This may damage the motherboard.

Step 4

  • Remove the two screws from the motherboard using the #0 Phillips screwdriver.

Remove the two screws from the motherboard using the #0 Phillips screwdriver.

Step 5

  • Remove the rumble motors from their slots and allow them to hang freely.
  • Remove the motherboard from the controller by lifting up.

Remove the rumble motors from their slots and allow them to hang freely.

Remove the motherboard from the controller by lifting up.

Step 6

  • Wipe the outer face of the analog sticks with a wet cotton swab or paper towel.

Wipe the outer face of the analog sticks with a wet cotton swab or paper towel.

Step 7

  • Wipe the button pads with a wet cotton swab or paper towel.

Wipe the button pads with a wet cotton swab or paper towel.

Step 8

  • Remove the buttons from their slots by pushing them in from the front.
  • Wipe the buttons with a wet cotton swab or paper towel

Remove the buttons from their slots by pushing them in from the front.

Wipe the buttons with a wet cotton swab or paper towel

After allowing the controller time to dry, reassemble your device by following these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Dan Heckman

Member since: 10/05/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Michigan Tech, Team S3-G11, Galliah Fall 2017                        

                                                  Member of Michigan Tech, Team S3-G11, Galliah Fall 2017 



                    MTU-GALLIAH-F17S3G11                     


                                            1 Member                     


                                            1 Guide authored