Featured

Featured Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes

Sections

1

  • How to Open the GuliKit KingKong 2 Pro
  • 5 steps

Flags

This guide has been found to be exceptionally cool by the iFixit staff.

  • BackGuliKit KingKong 2 Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Unfasten the back cover screws
  • Use a Phillips #00 screwdriver to remove the four 11 mm-long screws securing the back cover.

Use a Phillips #00 screwdriver to remove the four 11 mm-long screws securing the back cover.

1024

Step 2

              Insert an opening pick
  • The back cover of the GuliKit Kingkong 2 Pro is held in place by plastic clips.
  • Insert an opening pick into the gap between the front assembly and the back cover at the bottom edge of the controller.
  • Tilt your opening pick downwards to widen the gap.

The back cover of the GuliKit Kingkong 2 Pro is held in place by plastic clips.

Insert an opening pick into the gap between the front assembly and the back cover at the bottom edge of the controller.

Tilt your opening pick downwards to widen the gap.

Step 3

              Separate the front assembly and back cover
  • Insert an opening pick into the gap between the front assembly and the back cover at the outside of the right controller handle.
  • Slide the opening pick along the gap to separate the front assembly from the back cover.

Insert an opening pick into the gap between the front assembly and the back cover at the outside of the right controller handle.

Slide the opening pick along the gap to separate the front assembly from the back cover.

Step 4

  • Insert an opening pick into the gap between the front assembly and the back cover at the outside of the left controller handle.
  • Slide the opening pick along the gap to separate the front assembly from the back cover.

Insert an opening pick into the gap between the front assembly and the back cover at the outside of the left controller handle.

Step 5

              Remove the back cover
  • Separate the back cover from the front assembly and remove it.

Separate the back cover from the front assembly and remove it.

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Dominik Schnabelrauch

Member since: 11/23/2016

158,135 Reputation

                                      649 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored