Difficulty

Moderate

Steps

5

Time Required

                          5 - 10 minutes

Sections

1

  • How to Open the Samsung Galaxy Watch4 Classic
  • 5 steps

Flags

0

  • BackSamsung Galaxy Watch4 Classic

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power down your watch
  • Before starting repairs, take your watch off the charger and power it down.
  • Remove the watch band.

Before starting repairs, take your watch off the charger and power it down.

Remove the watch band.

1024

Step 2

              Unscrew the back cover
  • Use a Tri-point Y000 screwdriver to remove the four 4.0 mm-long screws securing the back cover.

Use a Tri-point Y000 screwdriver to remove the four 4.0 mm-long screws securing the back cover.

Step 3

              Pry open the back cover
  • Insert an opening tool into the seam between the back cover and the metal housing.
  • Twist the opening tool to create a gap.
  • Don’t try to remove the back cover all the way yet. The sensor flex cable is still connected to the motherboard.

Insert an opening tool into the seam between the back cover and the metal housing.

Twist the opening tool to create a gap.

Don’t try to remove the back cover all the way yet. The sensor flex cable is still connected to the motherboard.

Step 4

              Disconnect the sensor flex cable
  • Lay the watch face down.
  • Carefully swing open the back cover by folding it to the opposite site of the created gap.
  • Use the flat end of a spudger to pry up and disconnect the sensor flex cable from the motherboard.

Lay the watch face down.

Carefully swing open the back cover by folding it to the opposite site of the created gap.

Use the flat end of a spudger to pry up and disconnect the sensor flex cable from the motherboard.

Step 5

              Remove the back cover
  • Remove the back cover.
  • Make sure the rubber gasket is undamaged. If damaged, replace it with a new one during reassembly to maintain proper water resistance.

Remove the back cover.

Make sure the rubber gasket is undamaged. If damaged, replace it with a new one during reassembly to maintain proper water resistance.

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Adriana Zwink

Member since: 12/18/2019

36,607 Reputation

                                      167 Guides authored                  



                       Badges:
                       34







                                                        +31 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored