Difficulty
Moderate
Steps
10
Time Required
5 - 10 minutes
Sections
1
- How to open the SteelSeries Nimbus+ Controller
- 10 steps
Flags
0
BackSteelSeries Nimbus+
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the phone mount
- Use your fingers to remove the phone mount by pulling it straight out of the controller.
Use your fingers to remove the phone mount by pulling it straight out of the controller.
1024
Step 2
Remove the sticker
- Use your fingers to remove the sticker located on the back cover of the Nimbus+.
- If you have trouble removing the sticker heat an iOpener and apply it to the rear case for two minutes to loosen the adhesive underneath.
Use your fingers to remove the sticker located on the back cover of the Nimbus+.
If you have trouble removing the sticker heat an iOpener and apply it to the rear case for two minutes to loosen the adhesive underneath.
Step 3
Unscrew the back cover
- Use a Y1 Tri-point screwdriver to remove the five 9.1 mm-long screws securing the back cover.
Use a Y1 Tri-point screwdriver to remove the five 9.1 mm-long screws securing the back cover.
Step 4
Insert an opening pick
- The back cover is held in place by plastic clips.
- Insert an opening pick into the gap between the front and back cover assembly at the outside of the right controller handle.
The back cover is held in place by plastic clips.
Insert an opening pick into the gap between the front and back cover assembly at the outside of the right controller handle.
Step 5
Release the plastic clips
- Slide the opening pick to the top of the controller to release the remaining plastic clips on the right edge.
Slide the opening pick to the top of the controller to release the remaining plastic clips on the right edge.
Step 6
Insert an opening pick
- Insert an opening pick into the gap between the front and back cover assembly at the outside of the left controller handle.
Insert an opening pick into the gap between the front and back cover assembly at the outside of the left controller handle.
Step 7
Release the plastic clips
- Slide the opening pick to the top of the controller to release the remaining plastic clips on the left edge.
Slide the opening pick to the top of the controller to release the remaining plastic clips on the left edge.
Step 8
Unfold the back cover assembly
- Carefully fold the back cover assembly to the top of the SteelSeries Nimbus+ and bring it in an 90 degree angle.
- Do not try to remove the back cover assembly all the way yet! It is still connected to mainboard.
Carefully fold the back cover assembly to the top of the SteelSeries Nimbus+ and bring it in an 90 degree angle.
Do not try to remove the back cover assembly all the way yet! It is still connected to mainboard.
Step 9
Disconnect the battery cable
- Use a pair of blunt nose tweezers to disconnect the battery cable from the mainboard.
Use a pair of blunt nose tweezers to disconnect the battery cable from the mainboard.
Step 10
Remove the back cover assembly
- Remove the back cover assembly.
Remove the back cover assembly.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
Cancel: I did not complete this guide.
Author
Adriana Zwink
Member since: 12/18/2019
36,607 Reputation
167 Guides authored
Badges:
34
+31 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored
