Difficulty
Moderate
Steps
4
Time Required
5 - 10 minutes
Sections
1
- How to open the TicWatchPro
- 4 steps
Flags
0
BackTicWatchPro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unfasten the screws
- Before starting repairs, take your watch off the charger and power it down.
- Remove the four 3.9 mm-long Torx T3 screws.
- Don’t try to detach the back cover yet. It is still connected to the watch assembly.
Before starting repairs, take your watch off the charger and power it down.
Remove the four 3.9 mm-long Torx T3 screws.
Don’t try to detach the back cover yet. It is still connected to the watch assembly.
1024
Step 2
Open the watch
- Be careful not to strain the sensor flex cable during this procedure.
- Carefully lift the back cover by the watch crown edge and swing it open to an upward position.
Be careful not to strain the sensor flex cable during this procedure.
Carefully lift the back cover by the watch crown edge and swing it open to an upward position.
Step 3
Disconnect the sensor cable
- Use the flat end of a spudger to pry up and disconnect the sensor flex cable.
Use the flat end of a spudger to pry up and disconnect the sensor flex cable.
Step 4
Remove the back cover
- Remove the back cover.
Remove the back cover.
To reassemble your device, follow these instructions in reverse order.
Repair didn’t go as planned? Check out our Answers community for help.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
Dominik Schnabelrauch
Member since: 11/23/2016
158,135 Reputation
649 Guides authored
Badges:
40
+37 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored