Difficulty
Moderate
Steps
3
Time Required
40 minutes
Sections
1
- How to Remove Screen Google Nest Hub
- 3 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackGoogle Nest Hub
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Video Overview
Step 1
Breaking Glue Connection
- The unit has no retaining clips on the top or bottom but the top where the camera eye is located is the easiest to get a pry tool into. A heat gun is recommended to soften the glue but I found I didn’t need it to get the glass off (but my thumb may never be the same again)
- avoiding going in directly where the camera is your only looking to go a few MM in as the glass is glued on and its just the thickness of the glass top and bottom.
- Working your way round you should find two studs at each side at around the same level as the glass top and bottom.
The unit has no retaining clips on the top or bottom but the top where the camera eye is located is the easiest to get a pry tool into. A heat gun is recommended to soften the glue but I found I didn’t need it to get the glass off (but my thumb may never be the same again)
avoiding going in directly where the camera is your only looking to go a few MM in as the glass is glued on and its just the thickness of the glass top and bottom.
Working your way round you should find two studs at each side at around the same level as the glass top and bottom.
1024
Step 2
Remove Screen Ribbon
- Once you get the glass off take care to not rip the ribbon. picture one is the ribbon locked in the closed position (no ribbon shown but the input to the slot is marked with the triangle and the number 1 bottom left )
- Red arrow shows where to lift the locking arm the blue arrow shows the ribbon insertion direction
Once you get the glass off take care to not rip the ribbon. picture one is the ribbon locked in the closed position (no ribbon shown but the input to the slot is marked with the triangle and the number 1 bottom left )
Red arrow shows where to lift the locking arm the blue arrow shows the ribbon insertion direction
Step 3
Clean Screen Area
- Clean up the excess glue around the edges and wait for your new screen to arrive.
Clean up the excess glue around the edges and wait for your new screen to arrive.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Jason Nairn
Member since: 12/10/2020
154 Reputation
1 Guide authored
Badges:
4
+1 more badge
Dan Bradnam - Feb 5, 2022
Reply
What width is the tape you used?
Jason Nairn - Aug 24, 2022
what tape? the new screen had glue round it just popped it back in ( only just noticed now they have added a video! that isn’t me)
Chi Akuma - Aug 20, 2022
Reply
The link from AliBaba doesnt work. How do i find another?
