Difficulty

Moderate

Steps

5

Time Required

                          15 - 20 minutes

Sections

1

  • How to remove the 2010-2017 Suzuki Swift front bumper
  • 5 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • Back2010-2017 Suzuki Swift

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

If you are replacing your front bumper, don’t forget to install the license plate.

What you need

Step 1

              remove the top fasteners
  • Open the hood and unscrew the 10mm bolts located at the top.
  • Unscrew the screw located at the side top corner under the fender, repeat on the other side.

Open the hood and unscrew the 10mm bolts located at the top.

Unscrew the screw located at the side top corner under the fender, repeat on the other side.

1024

Step 2

              remove bottom fasteners
  • Unscrew 4 screws located underneath the front of the front bumper.
  • With the flathead, unclip the 2 push rivets underneath the side of the front bumper, disconnecting each fender from the bumper.
  • Repeat on the other side.

Unscrew 4 screws located underneath the front of the front bumper.

With the flathead, unclip the 2 push rivets underneath the side of the front bumper, disconnecting each fender from the bumper.

Repeat on the other side.

Step 3

              detach top corners
  • Gently, pull the side corner loose.
  • Pull from the car and slightly downwards to detach the remaining corner.
  • Repeat on the other side.

Gently, pull the side corner loose.

Pull from the car and slightly downwards to detach the remaining corner.

Step 4

              unlatch the bumper
  • If your car has fog lights, make sure you disconnect them from the car’s wiring.
  • The bumper is now only attached with 2 clips at the top.
  • Push the front of each clip towards the car and unlatch it.

If your car has fog lights, make sure you disconnect them from the car’s wiring.

The bumper is now only attached with 2 clips at the top.

Push the front of each clip towards the car and unlatch it.

Step 5

              remove the bumper
  • Hold the bumper in the center and remove it by moving it down and outwards.
  • The bumper wraps around the bottom and fender parts, take care not to damage anything when removing the bumper.
  • Some of the 4 bottom nut clips might move or detach entirely when removing the bumper. Ensure these are at their correct positions.

Hold the bumper in the center and remove it by moving it down and outwards.

The bumper wraps around the bottom and fender parts, take care not to damage anything when removing the bumper.

Some of the 4 bottom nut clips might move or detach entirely when removing the bumper. Ensure these are at their correct positions.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    knipwim

Member since: 09/01/2018

7,452 Reputation

                                      29 Guides authored                  



                       Badges:
                       37







                                                        +34 more badges