Difficulty

Very easy

Steps

5

Time Required

                          5 minutes

Sections

1

  • How to Reset the Automatic Mechanism in an Audio Technica AT-LP60BK Turntable
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackTurntable

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              How to Reset the Automatic Mechanism in an Audio Technica AT-LP60BK Turntable
  • Carefully remove the plastic cover and set aside.

Carefully remove the plastic cover and set aside.

1024

Step 2

  • Remove the pad if there is one.
  • Spin the turntable until the belt and drive motor can be seen through a hole.
  • Gently pull the belt off of the motor, and make sure that the belt doesn’t bend or flip over.
  • Take off the turntable platter and set aside.

Remove the pad if there is one.

Spin the turntable until the belt and drive motor can be seen through a hole.

Gently pull the belt off of the motor, and make sure that the belt doesn’t bend or flip over.

Take off the turntable platter and set aside.

Step 3

  • Remove the single screw from the middle white gear with a Phillips #00 screwdriver.
  • Have a cup or bin so you don’t lose the screw!
  • Gently pull the gear out, revealing the automatic mechanism.

Remove the single screw from the middle white gear with a Phillips #00 screwdriver.

Have a cup or bin so you don’t lose the screw!

Gently pull the gear out, revealing the automatic mechanism.

Step 4

  • Push the metal part away from the center. It should click into place.
  • Push the small metal part back to the center, towards the gear axle.
  • Push the metal part inward, close to the gear’s mounting point.

Push the metal part away from the center. It should click into place.

Push the small metal part back to the center, towards the gear axle.

Push the metal part inward, close to the gear’s mounting point.

Step 5

  • Replace the gear, making sure that the the metal latch on the gear is pushed back.
  • The central shaft should spin freely without hooking the gear.
  • Don’t forget to put the band back on the drive motor when reassembling.

Replace the gear, making sure that the the metal latch on the gear is pushed back.

The central shaft should spin freely without hooking the gear.

Don’t forget to put the band back on the drive motor when reassembling.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Devin Hoopes

Member since: 09/08/2021

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Embry-Riddle Aeronautical University, Team 1-6, Rauch Fall 2021                        

                                                  Member of Embry-Riddle Aeronautical University, Team 1-6, Rauch Fall 2021 



                    ERAU-RAUCH-F21S1G6                     


                                            3 Members                     


                                            1 Guide authored