Difficulty

Easy

Steps

6

Time Required

                          9 - 10 minutes

Sections

3

  • Battery
  • 1 step
  • Back Panel
  • 2 steps
  • Daughterboard
  • 3 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHP 14-am052nr

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Turn the laptop over to its bottom so that the backside is facing you.
  • Using your fingers, push the two locking tabs inwards to release the battery.
  • Remove the battery from the device.

Turn the laptop over to its bottom so that the backside is facing you.

Using your fingers, push the two locking tabs inwards to release the battery.

Remove the battery from the device.

1024

Step 2

              Back Panel
  • After removing the battery with the laptop on its back, expose screws that are hidden under the rubber feet and the center label.
  • Using the Phillips #0 screwdriver, remove fourteen (14) 6 mm screws from the back panel.

After removing the battery with the laptop on its back, expose screws that are hidden under the rubber feet and the center label.

Using the Phillips #0 screwdriver, remove fourteen (14) 6 mm screws from the back panel.

Step 3

  • Use a prying tool to remove the back panel from the base of the computer.

Use a prying tool to remove the back panel from the base of the computer.

Step 4

              Daughterboard
  • Disconnect the daughterboard from the connector with your thumb and pointer finger.

Disconnect the daughterboard from the connector with your thumb and pointer finger.

Step 5

  • Use the Phillips #0 screwdriver to remove three 3 mm screws.

Use the Phillips #0 screwdriver to remove three 3 mm screws.

Step 6

  • Remove the daughterboard from the device.

Remove the daughterboard from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Paige Fonseca

Member since: 10/25/2021

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       UMass Dartmouth, Team 3-3, Sinclaire Fall 2021                        

                                                  Member of UMass Dartmouth, Team 3-3, Sinclaire Fall 2021 



                    UMASSD-SINCLAIRE-F21S3G3                     


                                            3 Members                     


                                            7 Guides authored