Difficulty
Moderate
Steps
7
Time Required
20 minutes
Sections
3
- Front Panel Assembly
- 4 steps
- Keyboard
- 2 steps
- CD Drive
- 1 step
Flags
0
BackHP 15-r137wm TouchSmart
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Panel Assembly
- Make sure that the device is powered off and unplugged before removing components.
- Remove all ten (10) 5.5 mm Phillips #0 screws.
- Remove the two (2) plastic tabs located at the rear of the panel. Locate the two (2) 7.5mm Phillips #0 screws underneath the pads and remove.
Make sure that the device is powered off and unplugged before removing components.
Remove all ten (10) 5.5 mm Phillips #0 screws.
Remove the two (2) plastic tabs located at the rear of the panel. Locate the two (2) 7.5mm Phillips #0 screws underneath the pads and remove.
1024
Step 2
- Use a wide plastic opening tool to pry off the top casing.
- Be cautious not to crack the casing near the keyboard as it is quite fragile.
- Lift the cover off carefully as there are wires still attached to internal components.
- After panel is removed, use an anti-static wrist strap to ensure the motherboard does not get any external shocks from static discharge.
Use a wide plastic opening tool to pry off the top casing.
Be cautious not to crack the casing near the keyboard as it is quite fragile.
Lift the cover off carefully as there are wires still attached to internal components.
After panel is removed, use an anti-static wrist strap to ensure the motherboard does not get any external shocks from static discharge.
Step 3
- The connection for the track pad is still connected.
- Move the keyboard slightly out of the way to locate the connection.
- Disconnect the small wire protruding from the motherboard underneath the metal plate.
The connection for the track pad is still connected.
Move the keyboard slightly out of the way to locate the connection.
Disconnect the small wire protruding from the motherboard underneath the metal plate.
Step 4
- Locate the connection between the power button and the connecting cable.
- Do not lift the front panel off to far as the cable is still attached.
- Remove the cable from the motherboard carefully.
Locate the connection between the power button and the connecting cable.
Do not lift the front panel off to far as the cable is still attached.
Remove the cable from the motherboard carefully.
Step 5
Keyboard
- Disconnect the connection between the keyboard the the motherboard.
Disconnect the connection between the keyboard the the motherboard.
Step 6
- Remove the four (4) 2.5mm by 3.5mm Phillips #0 screws from the metal retaining plate.
- Lift the metal retaining plate off and away from the device.
Remove the four (4) 2.5mm by 3.5mm Phillips #0 screws from the metal retaining plate.
Lift the metal retaining plate off and away from the device.
Step 7
CD Drive
- Slide the CD drive out slowly by pulling it to the right. There are no screws attached, but there is a connection to the motherboard.
Slide the CD drive out slowly by pulling it to the right. There are no screws attached, but there is a connection to the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Ross B Jacques
Member since: 10/18/2017
857 Reputation
7 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team S4-G4, Julie Fall 2017
Member of UMass Dartmouth, Team S4-G4, Julie Fall 2017
UMASSD-JULIE-F17S4G4
3 Members
7 Guides authored
