Difficulty

Moderate

Steps

4

Time Required

                          8 minutes

Sections

1

  • WiFi Card
  • 4 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHP Notebook 17-x027ds

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              WiFi Card
  • Flip the laptop so you can see the serial number and the four 7mm screws in all the corners.
  • Click the hinges by pushing them inward, which are located at the top.
  • Remove the battery by pulling it out.

Flip the laptop so you can see the serial number and the four 7mm screws in all the corners.

Click the hinges by pushing them inward, which are located at the top.

Remove the battery by pulling it out.

1024

Step 2

  • Remove the 2 pieces of black tape that are each covering a 7mm screw at the top corners of the laptop.
  • When removing the 2 black pieces of tape, keep the tape so you can place it back on the laptop again when reassembling.
  • Remove the fourteen 7mm screws with a JIS #00 screwdriver.

Remove the 2 pieces of black tape that are each covering a 7mm screw at the top corners of the laptop.

When removing the 2 black pieces of tape, keep the tape so you can place it back on the laptop again when reassembling.

Remove the fourteen 7mm screws with a JIS #00 screwdriver.

Step 3

  • Lift the bottom cover of the laptop with a metal spudger by wedging the sides first and going all around.
  • The cover is difficult to lift, so use extreme force.

Lift the bottom cover of the laptop with a metal spudger by wedging the sides first and going all around.

The cover is difficult to lift, so use extreme force.

Step 4

  • Carefully pull the two cables attached to the CPU.
  • They are labeled 1 and 2. When putting the cables back, make sure to put them in the correct section.
  • Remove the screw holding down the CPU with the same screwdriver tip as before.
  • Gently pull on the CPU to remove it.

Carefully pull the two cables attached to the CPU.

They are labeled 1 and 2. When putting the cables back, make sure to put them in the correct section.

Remove the screw holding down the CPU with the same screwdriver tip as before.

Gently pull on the CPU to remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Tyrin

Member since: 09/20/2018

188 Reputation

                                      2 Guides authored                  



                       Badges:
                       2

Team

                       University of North Texas, Team S3-G1, Raign Fall 2018                        

                                                  Member of University of North Texas, Team S3-G1, Raign Fall 2018 



                    UNT-RAIGN-F18S3G1                     


                                            4 Members                     


                                            5 Guides authored