Difficulty

Moderate

Steps

6

Time Required

                          5 minutes

Sections

2

  • Back Panel
  • 3 steps
  • Front-Facing Camera
  • 3 steps

Flags

0

  • BackHP 8 1401

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.

Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.

1024

Step 2

  • Insert the tip of a plastic opening tool in the seam between the front and back panels.

Insert the tip of a plastic opening tool in the seam between the front and back panels.

Step 3

  • Slide the plastic opening tool around all edges of the device until the back panel detaches.
  • Lift off the back panel.

Slide the plastic opening tool around all edges of the device until the back panel detaches.

Lift off the back panel.

Step 4

              Front-Facing Camera
  • Place the tip of your spudger under the edge of the press fit connector, and pry the connector straight up from its socket.

Place the tip of your spudger under the edge of the press fit connector, and pry the connector straight up from its socket.

Step 5

  • Lift the front-facing camera out of the tablet.

Lift the front-facing camera out of the tablet.

Step 6

  • After the front-facing camera has been removed, the tablet should look like this.

After the front-facing camera has been removed, the tablet should look like this.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Katie Presz

Member since: 01/16/2019

641 Reputation

                                      6 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       University of Alabama, Team S1-G1, Bedsole Spring 2019                        

                                                  Member of University of Alabama, Team S1-G1, Bedsole Spring 2019 



                    UA-BEDSOLE-S19S1G1                     


                                            4 Members                     


                                            6 Guides authored