Difficulty
Moderate
Steps
4
Time Required
5 minutes
Sections
2
- Back Panel
- 3 steps
- Rear-Facing Camera
- 1 step
Flags
0
BackHP 8 1401
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.
Using a Torx T4 screwdriver, remove the four 5 mm screws on the back panel.
1024
Step 2
- Insert the tip of a plastic opening tool in the seam between the front and back panels.
Insert the tip of a plastic opening tool in the seam between the front and back panels.
Step 3
- Slide the plastic opening tool around all edges of the device until the back panel detaches.
- Lift off the back panel.
Slide the plastic opening tool around all edges of the device until the back panel detaches.
Lift off the back panel.
Step 4
Rear-Facing Camera
- Place the tip of your spudger under the edge of the press fit connector, and pry the connector straight up from its socket.
- Lift the rear-facing camera out of its compartment using the tweezers.
Place the tip of your spudger under the edge of the press fit connector, and pry the connector straight up from its socket.
Lift the rear-facing camera out of its compartment using the tweezers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Katie Presz
Member since: 01/16/2019
641 Reputation
6 Guides authored
Badges:
6
+3 more badges
Team
University of Alabama, Team S1-G1, Bedsole Spring 2019
Member of University of Alabama, Team S1-G1, Bedsole Spring 2019
UA-BEDSOLE-S19S1G1
4 Members
6 Guides authored
