Hp Chromebook 11 2210Nr Speakers Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          35 minutes

Sections

Speakers
12 steps

Flags

BackHP Chromebook 11-2210nr
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Speakers

Position your closed laptop face down to remove the 9 visible 6mm screws using the Phillips #1 screwdriver.

Position your closed laptop face down to remove the 9 visible 6mm screws using the Phillips #1 screwdriver.

1024

Step 2

Using the metal spudger, remove the two rubber pads that are closer to the hinge of the laptop.
Remove the two additional 6mm screws located beneath the rubber pads using the Phillips #1 screwdriver.
The two bottom rubber pads do not contain screws, but you may check if you wish to be sure.

Using the metal spudger, remove the two rubber pads that are closer to the hinge of the laptop.

Remove the two additional 6mm screws located beneath the rubber pads using the Phillips #1 screwdriver.

The two bottom rubber pads do not contain screws, but you may check if you wish to be sure.

Step 3

Turn the Laptop over and with the metal spudger start to run it along the plastic seam to pry it off.
You will hear popping sounds when you are sliding the spudger along the device.
For an easier removal, start from the sides and work your way in to the corners.

Turn the Laptop over and with the metal spudger start to run it along the plastic seam to pry it off.

You will hear popping sounds when you are sliding the spudger along the device.

For an easier removal, start from the sides and work your way in to the corners.

Step 4

Carefully lift off the keyboard and gently place it towards you until the two ZIF ribbon wires become visible and place the keyboard down.
Locate where the two ZIF ribbon wires are connecting the keyboard to the motherboard in place by clasps.
This does not disconnect the keyboard from the laptop just yet.

Carefully lift off the keyboard and gently place it towards you until the two ZIF ribbon wires become visible and place the keyboard down.

Locate where the two ZIF ribbon wires are connecting the keyboard to the motherboard in place by clasps.

This does not disconnect the keyboard from the laptop just yet.

Step 5

Using the nylon spudger, lift the plastic clasps holding the two ribbon wires up to properly disconnect the wires.
It is recommended to use the nylon spudger for this step. Any metal can damage your motherboard.
This step completely disconnects the keyboard to allow safe removal and replacement.

Using the nylon spudger, lift the plastic clasps holding the two ribbon wires up to properly disconnect the wires.

It is recommended to use the nylon spudger for this step. Any metal can damage your motherboard.

This step completely disconnects the keyboard to allow safe removal and replacement.

Step 6

Remove the six 4mm screws holding the battery in place with a Phillips #1 screwdriver.

Remove the six 4mm screws holding the battery in place with a Phillips #1 screwdriver.

Step 7

Carefully unplug the bundle power cable by pulling both edges towards you.
This successfully disconnects the battery from the laptop.

Carefully unplug the bundle power cable by pulling both edges towards you.

This successfully disconnects the battery from the laptop.

Step 8

Carefully lift the battery and safely remove it out of the laptop.
The battery may have an adhesive sticker attached to the bottom. If so, apply more force when lifting it up.
After the removal of the battery, the speakers will become accessible.

Carefully lift the battery and safely remove it out of the laptop.

The battery may have an adhesive sticker attached to the bottom. If so, apply more force when lifting it up.

After the removal of the battery, the speakers will become accessible.

Step 9

Use the metal spudger to release the LEFT speakers from the laptop.
Use the metal spudger to release the RIGHT speaker from the laptop.
The two speakers are connected to a wire that runs along the bottom edge of the laptop and connected up to the motherboard.

Use the metal spudger to release the LEFT speakers from the laptop.

Use the metal spudger to release the RIGHT speaker from the laptop.

The two speakers are connected to a wire that runs along the bottom edge of the laptop and connected up to the motherboard.

Step 10

Unplug the speakers small wire bundle from the motherboard.
You will notice the speaker wire is pinched between a screw slot and underneath the motherboard.

Unplug the speakers small wire bundle from the motherboard.

You will notice the speaker wire is pinched between a screw slot and underneath the motherboard.

Step 11

Remove the one 4mm screw located above the pinched wire.

Remove the one 4mm screw located above the pinched wire.

Step 12

Using the nylon spudger, slightly pry up the motherboard to release the pinched wire.
This step completely disconnects the speaker from the laptop to be safely removed.

Using the nylon spudger, slightly pry up the motherboard to release the pinched wire.

This step completely disconnects the speaker from the laptop to be safely removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Gerardo Cardona

Member since: 10/02/2018

364 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       Sam Houston State, Team S11-G3, Blackburne Fall 2018                        

                                                  Member of Sam Houston State, Team S11-G3, Blackburne Fall 2018 



                    SHSU-BLACKBURNE-F18S11G3                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team