Hp Chromebook 11 G5 Screen Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

Screen
6 steps

Flags

BackHP Chromebook 11 G5
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Open the lid as far as possible.
Slide your spudger into the bezel of the laptop until it appears on the other side.
Make your way around the bezel with the spudger while gently prying up the bezel to snap it out of place.
You should hear an audible click when the snap is removed.
Make sure there is a gap between the spudger and the components behind the bezel while prying.

Open the lid as far as possible.

Slide your spudger into the bezel of the laptop until it appears on the other side.

Make your way around the bezel with the spudger while gently prying up the bezel to snap it out of place.

You should hear an audible click when the snap is removed.

Make sure there is a gap between the spudger and the components behind the bezel while prying.

1024

Step 2

Hold the bezel on both sides, and twist the bezel repeatedly until the bottom bezel snaps out of place.
This step is likely the most difficult, and you may have to use additional force to remove the bezel.

Hold the bezel on both sides, and twist the bezel repeatedly until the bottom bezel snaps out of place.

This step is likely the most difficult, and you may have to use additional force to remove the bezel.

Step 3

Unscrew the four silver 4mm Phillips #0 screws on the edges of the display.
To ensure that the LCD panel does not immediately slide down upon removing the screws, make sure the display is still tilted as far back as possible.

Unscrew the four silver 4mm Phillips #0 screws on the edges of the display.

To ensure that the LCD panel does not immediately slide down upon removing the screws, make sure the display is still tilted as far back as possible.

Step 4

Gently lift the LCD panel out of the body and lower it onto the keyboard deck.
Ensure that the power button is not accidentally pressed while lowering the display.

Gently lift the LCD panel out of the body and lower it onto the keyboard deck.

Ensure that the power button is not accidentally pressed while lowering the display.

Step 5

Identify the eDP 30-pin connector and use the sharp end of the spudger to peel off a corner of the tape over the connector.
To avoid damaging internal components, only use a metal spudger as a last resort.
Use your fingers to peel off the rest of the tape.
Peel the tape slowly to ensure that the connector does not get pulled while peeling the tape.

Identify the eDP 30-pin connector and use the sharp end of the spudger to peel off a corner of the tape over the connector.

To avoid damaging internal components, only use a metal spudger as a last resort.

Use your fingers to peel off the rest of the tape.

Peel the tape slowly to ensure that the connector does not get pulled while peeling the tape.

Step 6

Hold both sides of the tape and gently push back the connector to disconnect the display.
When attaching the new display, make sure there is no gap between the connector and its socket.
Two audible clicks should be heard when the connector is reattached, one click for each side of the connector.

Hold both sides of the tape and gently push back the connector to disconnect the display.

When attaching the new display, make sure there is no gap between the connector and its socket.

Two audible clicks should be heard when the connector is reattached, one click for each side of the connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors

                    Kunal  Chopra

Member since: 01/14/2020

474 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       York University, Team S1-G3, Woodhouse Winter 2020                        

                                                  Member of York University, Team S1-G3, Woodhouse Winter 2020 



                    YORK-WOODHOUSE-W20S1G3                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team