Hp Chromebox J5N50Ut Bottom Shield Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          5 - 10 minutes            

Sections

2

• Bottom Cover
• 4 steps
• Bottom Shield
• 3 steps

Flags

0

• BackHP Chromebox J5N50UT

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Bottom Cover               

• Before removing the bottom cover, ensure that your computer is powered down and ensure that all external devices are disconnected. If you are unsure whether the computer is off or in hibernation mode, turn the computer on, then shut it down through the operating system.
• Position the device upside-down on a flat, level surface with the USB ports facing you.

Before removing the bottom cover, ensure that your computer is powered down and ensure that all external devices are disconnected. If you are unsure whether the computer is off or in hibernation mode, turn the computer on, then shut it down through the operating system.

Position the device upside-down on a flat, level surface with the USB ports facing you.

1024

Step 2

• Using your metal spudger, lift and remove the 4 rubber “feet” from each corner.

Using your metal spudger, lift and remove the 4 rubber “feet” from each corner.

Step 3

• Using your Phillips head screwdriver, remove the four Phillips M2.5×4.0 screws that secure the bottom cover to the computer. In this step the usage of the magnetic mat will be helpful to keep up with the screws.

Using your Phillips head screwdriver, remove the four Phillips M2.5×4.0 screws that secure the bottom cover to the computer. In this step the usage of the magnetic mat will be helpful to keep up with the screws.

Step 4

• Insert the flat end of your metal spudger under the bottom cover near the USB ports, then pry the bottom cover off the computer.

Insert the flat end of your metal spudger under the bottom cover near the USB ports, then pry the bottom cover off the computer.

Step 5

              Bottom Shield               

• Lift the two pieces of mylar tape from the bracket.

Lift the two pieces of mylar tape from the bracket.

Step 6

• Using your Phillips #1 screwdriver, remove the four Phillips M2.5×4.0 screws that hold the shield in place.

Using your Phillips #1 screwdriver, remove the four Phillips M2.5×4.0 screws that hold the shield in place.

Step 7

• Insert your spudger into the gap between the bottom shield and the ports and gently pry to lift and remove the shield.

Insert your spudger into the gap between the bottom shield and the ports and gently pry to lift and remove the shield.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Ashley Marvin                     

Member since: 09/06/2018

661 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Ohio State, Team S1-G3, Whitney Fall 2018                        

                                                  Member of Ohio State, Team S1-G3, Whitney Fall 2018 



                    OSU-WHITNEY-F18S1G3                     


                                            2 Members                     


                                            5 Guides authored