Difficulty

Moderate

Steps

5

Time Required

                          5 - 7 minutes

Sections

2

  • Cover Removal
  • 3 steps
  • Paper Control Sensor
  • 2 steps

Flags

0

  • BackHP Deskjet 1000 J110a

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Cover Removal
  • Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped).

Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped).

1024

Step 2

  • In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer.

In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer.

Step 3

  • With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel.

With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel.

Step 4

              Paper Control Sensor
  • Locate the paper control sensor.
  • You can find the sensor, with the back of the printer facing you, on the right, and in front of the main circuit board. The paper control sensor will also be attached to a small circuit board. You will be replacing this circuit board.
  • Locate and unplug the connector which connects the sensor board to the main circuit board.
  • Use tweezers if unplugging by hand is too difficult.

Locate the paper control sensor.

You can find the sensor, with the back of the printer facing you, on the right, and in front of the main circuit board. The paper control sensor will also be attached to a small circuit board. You will be replacing this circuit board.

Locate and unplug the connector which connects the sensor board to the main circuit board.

Use tweezers if unplugging by hand is too difficult.

Step 5

  • Locate and remove the 8mm screw with a screwdriver and the T10 torx bit, then remove the paper control sensor board.
  • In this picture, the main circuit board is removed. It is not necessary to remove the main circuit board unless the paper control sensor is not the only part being replaced.

Locate and remove the 8mm screw with a screwdriver and the T10 torx bit, then remove the paper control sensor board.

In this picture, the main circuit board is removed. It is not necessary to remove the main circuit board unless the paper control sensor is not the only part being replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Colin Tourjee

Member since: 01/29/2018

632 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team S5-G3, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S5-G3, Passmore Spring 2018 



                    USFT-PASSMORE-S18S5G3                     


                                            4 Members                     


                                            6 Guides authored