Hp Deskjet 1000 J110A Plug Ports Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 7 minutes

Sections

Cover Removal
3 steps
Plug Ports
3 steps

Flags

BackHP Deskjet 1000 J110a
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Cover Removal

Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped).

Remove the two 13 mm screws located on the back of the printer using a screwdriver with the T10 torx bit (star-shaped).

1024

Step 2

In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer.

In the front of the printer, open the tray where the paper comes out and remove the two 13 mm screws located under the top of the printer.

Step 3

With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel.

With the front of the printer facing you, lift and raise the left side of the panel (like opening a book in reverse) until it disconnects from the clip on the right side of the panel.

Step 4

              Plug Ports

Locate and remove the two flat ribbon connectors which connect the circuit board to the other printer components.
Remove each connector using tweezers if it is too difficult to remove them by hand.

Locate and remove the two flat ribbon connectors which connect the circuit board to the other printer components.

Remove each connector using tweezers if it is too difficult to remove them by hand.

Step 5

Locate and remove the three multicolored wire connectors which connect the circuit board to the other printer components.
Remove each connector by hand, as shown. You can use tweezers if it is too difficult to remove them by hand.

Locate and remove the three multicolored wire connectors which connect the circuit board to the other printer components.

Remove each connector by hand, as shown. You can use tweezers if it is too difficult to remove them by hand.

Step 6

Remove the top two 13mm screws using a screwdriver with the T10 torx bit.
Remove the bottom 9mm screw using a screwdriver with the T10 torx bit, and remove the plug port circuit board.

Remove the top two 13mm screws using a screwdriver with the T10 torx bit.

Remove the bottom 9mm screw using a screwdriver with the T10 torx bit, and remove the plug port circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Chris Perez

Member since: 01/29/2018

247 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team S5-G3, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S5-G3, Passmore Spring 2018 



                    USFT-PASSMORE-S18S5G3                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team