Hp Deskjet 2624 Magnetic Strip Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          25 minutes

Sections

Magnetic Strip
5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackHP Deskjet 2624
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Magnetic Strip

Unplug the printer and remove all paper from the input tray.

Unplug the printer and remove all paper from the input tray.

1024

Step 2

Using the Torx T5 screwdriver, remove the four screws holding the scanner bed module to the printer base.
Slowly lift up the scanner bed slightly off the base.
Be sure to unplug the ribbons connecting the two parts by pulling them straight out of their plugs gently.

Using the Torx T5 screwdriver, remove the four screws holding the scanner bed module to the printer base.

Slowly lift up the scanner bed slightly off the base.

Be sure to unplug the ribbons connecting the two parts by pulling them straight out of their plugs gently.

Step 3

Gently lift the scanner bed module slightly off of the printer base. Be sure to carefully unplug the ribbon cables before fully removing the scanner bed.
Unplug the ribbon cables by pulling them gently straight out of their plugs.

Gently lift the scanner bed module slightly off of the printer base. Be sure to carefully unplug the ribbon cables before fully removing the scanner bed.

Unplug the ribbon cables by pulling them gently straight out of their plugs.

Step 4

Locate the magnetic strip found running straight through the ink cartridge carriage.

Locate the magnetic strip found running straight through the ink cartridge carriage.

Step 5

To remove the strip, start by applying pressure to the silver connection located on the right hand side of the strip.
While applying pressure to the right hand side, push the strip off the left hand hook and pull it straight up.
Lift the strip vertically and unhook it from the silver strip.
When putting the strip back in, ensure that the arrow on the replacement faces to the right and downwards.

To remove the strip, start by applying pressure to the silver connection located on the right hand side of the strip.

While applying pressure to the right hand side, push the strip off the left hand hook and pull it straight up.

Lift the strip vertically and unhook it from the silver strip.

When putting the strip back in, ensure that the arrow on the replacement faces to the right and downwards.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Ryan Doyle

Member since: 01/16/2020

551 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Embry-Riddle Aeronautical University, Team S6-G12, Rauch Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S6-G12, Rauch Spring 2020 



                    ERAU-RAUCH-S20S6G12                     


                                            4 Members                     


                                            5 Guides authored

Better Introduction#

Introduction#

What you need#

Team#

Better Introduction

Introduction

What you need

Team