Difficulty

Moderate

Steps

7

Time Required

                          20 - 30 minutes

Sections

3

  • Top Cover
  • 4 steps
  • Ink Cartridge Rail
  • 2 steps
  • Springs
  • 1 step

Flags

0

  • BackHP Deskjet D1660

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Top Cover
  • Remove the back two 14.0 mm Torx #10 screws.

Remove the back two 14.0 mm Torx #10 screws.

1024

Step 2

  • Lay the printer on its back.
  • Grab the paper tray by its right side and pull it to the left and up.

Lay the printer on its back.

Grab the paper tray by its right side and pull it to the left and up.

Step 3

  • Open the frontal access panel by lifting it from the top.
  • Similar to the paper tray, grab it from the right side and pull it to the left and up.

Open the frontal access panel by lifting it from the top.

Similar to the paper tray, grab it from the right side and pull it to the left and up.

Step 4

  • Take out the two frontal 14.0 mm Torx #10 screws.
  • Carefully lift the frontal cover.
  • Don’t lift it up aggressively. A strip will be attached to it.

Take out the two frontal 14.0 mm Torx #10 screws.

Carefully lift the frontal cover.

Don’t lift it up aggressively. A strip will be attached to it.

Step 5

              Ink Cartridge Rail
  • Remove the five 13.0 mm Torx #10 screws found on top of the frame.
  • Remove the four 9.0 mm Torx #10 smaller screws.

Remove the five 13.0 mm Torx #10 screws found on top of the frame.

Remove the four 9.0 mm Torx #10 smaller screws.

Step 6

  • Lift the rail carefully as a strip and motor will be connected to the bottom part of the printer.
  • Now detach the white strip and wires by gently lifting them up.

Lift the rail carefully as a strip and motor will be connected to the bottom part of the printer.

Now detach the white strip and wires by gently lifting them up.

Step 7

              Springs
  • Locate the springs. They will be on the side of the metal frame.
  • Using the tweezers, grab the loop of the spring that is connected to the bar.
  • Remove the spring by lifting the loop.

Locate the springs. They will be on the side of the metal frame.

Using the tweezers, grab the loop of the spring that is connected to the bar.

Remove the spring by lifting the loop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Justin Taiki Fukada

Member since: 01/25/2014

846 Reputation

                                      7 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 1-41, Maness Winter 2014                        

                                                  Member of Cal Poly, Team 1-41, Maness Winter 2014 



                    CPSU-MANESS-W14S1G41                     


                                            4 Members                     


                                            7 Guides authored