Hp Elitebook 1050 G1 Ssd Replacement Repair Guide

Difficulty

Moderate

Steps

3

Time Required

                          45 minutes            

Sections

1

• SSD
• 3 steps

Flags

0

• BackHP EliteBook 1050 G1

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

If looking to upgrade or replace the SSD in the HP EliteBook 1050 G1 laptop this guide will assist in doing so.

• Before buying or attempting to replace motherboard within this device make sure to do ample research to see if the SSD you are replacing the current with is compatible with this device.WARNING- While replacing this part make sure to be gentle and careful with all parts within the board and DO NOT allow small debris and dirt to enter the under the back casing doing so will shorten the life of the device.CAUTION- Use gloves while working with computer components because they may be sensitive to the oil on hands and skin.

What you need

Step 1

              SSD               

• Remove the two 5.5mm screws with a Torx T8 driver.
• Remove the five 8.7mm screws with a Torx T8 driver.
• Remove the two 6.6mm screws with a Torx T8 driver.
• Pry open the backplate with a Jimmy.

Remove the two 5.5mm screws with a Torx T8 driver.

Remove the five 8.7mm screws with a Torx T8 driver.

Remove the two 6.6mm screws with a Torx T8 driver.

Pry open the backplate with a Jimmy.

1024

Step 2

• Remove the two 1.9mm screws from the SSDs with a Phillips #0 driver.

Remove the two 1.9mm screws from the SSDs with a Phillips #0 driver.

Step 3

• With the screws removed, the SSD should pop up off of the board below.
• Disconnect the two PCIe SSDs by sliding them out of each port.
• When re-inserting the new SSDs make sure the white specs labels are facing up.

With the screws removed, the SSD should pop up off of the board below.

Disconnect the two PCIe SSDs by sliding them out of each port.

When re-inserting the new SSDs make sure the white specs labels are facing up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Elijah Holder                     

Member since: 09/16/2020

386 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       The Citadel Military College of South Carolina, Team S1-G5, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S1-G5, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S1G5                     


                                            3 Members                     


                                            3 Guides authored