Difficulty
Easy
Steps
5
Time Required
15 minutes
Sections
2
- Back Cover
- 2 steps
- Keyboard
- 3 steps
Flags
0
BackHP EliteBook 820 G3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the eleven 3 mm screws with a Phillips #00 screwdriver.
- Keep track of where the screw covers were attached to as there are four different sizes.
Remove the eleven 3 mm screws with a Phillips #00 screwdriver.
Keep track of where the screw covers were attached to as there are four different sizes.
1024
Step 2
- Remove the SD card blank and the single 3 mm screw beneath it using a Phillips #00 screwdriver.
- Lift off the back cover with your hands.
Remove the SD card blank and the single 3 mm screw beneath it using a Phillips #00 screwdriver.
Lift off the back cover with your hands.
Step 3
Keyboard
- Remove the two 3.4 mm keyboard screws found near the fan and on top of the hard drive using a Phillips #00 screwdriver.
Remove the two 3.4 mm keyboard screws found near the fan and on top of the hard drive using a Phillips #00 screwdriver.
Step 4
- Use an iFixit opening pick to gently pry open the top of the keyboard.
- Gently pull the keyboard up until you can see the three ribbons under the keyboard.
Use an iFixit opening pick to gently pry open the top of the keyboard.
Gently pull the keyboard up until you can see the three ribbons under the keyboard.
Step 5
- Lift up the latch holding down the ribbon and pull the ribbon out once it is lifted.
- Repeat for all three of the ribbons.
- The white ribbon (left ribbon) sometimes does not come with a new keyboard. You may need to detach it and add it to the replacement if necessary.
Lift up the latch holding down the ribbon and pull the ribbon out once it is lifted.
Repeat for all three of the ribbons.
The white ribbon (left ribbon) sometimes does not come with a new keyboard. You may need to detach it and add it to the replacement if necessary.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Caleb Morales
Member since: 08/25/2022
127 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
Gateway, Team 1-1, Class Fall 2022
Member of Gateway, Team 1-1, Class Fall 2022
GCC-CLASS-F22S1G1
4 Members
5 Guides authored