Difficulty
Easy
Steps
3
Time Required
7 minutes
Sections
2
- Back Cover
- 2 steps
- RAM
- 1 step
Flags
0
BackHP EliteBook 820 G3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the eleven 3 mm screws with a Phillips #00 screwdriver.
- Keep track of where the screw covers were attached to as there are four different sizes.
Remove the eleven 3 mm screws with a Phillips #00 screwdriver.
Keep track of where the screw covers were attached to as there are four different sizes.
1024
Step 2
- Remove the SD card blank and the single 3 mm screw beneath it using a Phillips #00 screwdriver.
- Lift off the back cover with your hands.
Remove the SD card blank and the single 3 mm screw beneath it using a Phillips #00 screwdriver.
Lift off the back cover with your hands.
Step 3
RAM
- Pull the two clips on either side of the RAM sideways at the same time.
- The top half of the stick will pop out of its plate.
- Pull the RAM stick out.
- Repeat this step with the other RAM stick.
Pull the two clips on either side of the RAM sideways at the same time.
The top half of the stick will pop out of its plate.
Pull the RAM stick out.
Repeat this step with the other RAM stick.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Nubia Pineda
Member since: 08/24/2022
76 Reputation
1 Guide authored
Badges:
2
Team
Gateway, Team 1-1, Class Fall 2022
Member of Gateway, Team 1-1, Class Fall 2022
GCC-CLASS-F22S1G1
4 Members
5 Guides authored
