Difficulty
Moderate
Steps
8
Time Required
20 - 35 minutes
Sections
3
- Back Cover
- 4 steps
- Battery Cable
- 1 step
- Wi-Fi Card
- 3 steps
Flags
0
BackHP EliteBook 830 x360 G6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Problems that you’re encountering that would permit you to follow this guide include;
- Unable to connect to WIFI
What you need
Step 1
Unfasten the back cover
- For your safety, discharge the battery below 25% and power down your device before disassembly.
- Use a Torx T5 screwdriver to loosen the five captive screws holding the back cover.
For your safety, discharge the battery below 25% and power down your device before disassembly.
Use a Torx T5 screwdriver to loosen the five captive screws holding the back cover.
1024
Step 2
Release the clips
- Insert an opening pick between a corner of the back corner and the chassis, near a hinge.
- Pry upward to release the retaining clips.
- These clips will make an audible click when they release.
- Repeat this process for the opposite corner.
Insert an opening pick between a corner of the back corner and the chassis, near a hinge.
Pry upward to release the retaining clips.
These clips will make an audible click when they release.
Repeat this process for the opposite corner.
Step 3
Release the remaining clips
- Insert your opening pick between the back cover and chassis, along the edge of the cover between the hinges.
- Pry up to release the additional retaining clips.
Insert your opening pick between the back cover and chassis, along the edge of the cover between the hinges.
Pry up to release the additional retaining clips.
Step 4
Remove the back cover
- Grab the cover by the corners next to the hinges.
- Swing the cover open and away from you.
- If the back cover feels stuck to the chassis, use an opening pick to release remaining clips around the perimeter of the back cover.
- Lift and remove the back cover from the laptop body.
Grab the cover by the corners next to the hinges.
Swing the cover open and away from you.
If the back cover feels stuck to the chassis, use an opening pick to release remaining clips around the perimeter of the back cover.
Lift and remove the back cover from the laptop body.
Step 5
Disconnect the battery
- Use the point of a spudger to push the sides of the battery connector out of its socket.
- Push on alternate sides to “walk” the connector out.
Use the point of a spudger to push the sides of the battery connector out of its socket.
Push on alternate sides to “walk” the connector out.
Step 6
Wi-Fi Card
- Remove the two antenna cable with tweezers.
- The blue tagged antenna will be on the left side. The red tagged antenna will be on the right side.
Remove the two antenna cable with tweezers.
The blue tagged antenna will be on the left side. The red tagged antenna will be on the right side.
Step 7
- Use a Phillips #0 screwdriver to remove the 3 mm screw securing the Wi-Fi card.
- The card will pop up at a slight angle once the screw is removed.
Use a Phillips #0 screwdriver to remove the 3 mm screw securing the Wi-Fi card.
The card will pop up at a slight angle once the screw is removed.
Step 8
- Grasp the sides of the Wi-Fi card to slide it out of the socket to remove.
- Gently remove the Wi-Fi card. There is risk of damage to the socket if removed forcefully.
Grasp the sides of the Wi-Fi card to slide it out of the socket to remove.
Gently remove the Wi-Fi card. There is risk of damage to the socket if removed forcefully.
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our HP EliteBook community for help.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Aeronel Jabile
Member since: 09/01/2021
316 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
Gateway, Team 1-2, Saknee Fall 2021
Member of Gateway, Team 1-2, Saknee Fall 2021
GCC-SAKNEE-F21S1G2
4 Members
6 Guides authored