Difficulty
Moderate
Steps
6
Time Required
30 minutes
Sections
2
- Battery
- 2 steps
- Screen
- 4 steps
Flags
0
BackHP EliteBook 8530w
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn the laptop off then place it down so that the back is facing up.
- Slide the battery release switch to the left and hold it there.
Turn the laptop off then place it down so that the back is facing up.
Slide the battery release switch to the left and hold it there.
1024
Step 2
- Pull the battery away upward and away from the laptop while continuing to hold the release switch.
- Once the battery is removed from the laptop, you may release the switch.
- To properly dispose of your battery, look for the closest location that accepts electronic waste in your area and drop it off there.
Pull the battery away upward and away from the laptop while continuing to hold the release switch.
Once the battery is removed from the laptop, you may release the switch.
To properly dispose of your battery, look for the closest location that accepts electronic waste in your area and drop it off there.
Step 3
Screen
- Turn the laptop off then place it down so that the top is facing up, then open the laptop.
- Remove the six screws around the screen bezel using a Phillips #00 screwdriver.
Turn the laptop off then place it down so that the top is facing up, then open the laptop.
Remove the six screws around the screen bezel using a Phillips #00 screwdriver.
Step 4
- Using a plastic opening tool, gently pry the bezel from the screen on all four sides.
- Remove the bezel.
Using a plastic opening tool, gently pry the bezel from the screen on all four sides.
Remove the bezel.
Step 5
- Lift the screen from the frame at the top of the laptop.
- At the bottom of the screen, there will be a cable connected to the body of the laptop. Remove this cable.
- On the back of the screen, there will be a ribbon cable that connects to it. Remove this cable by pinching the two tabs on the ends of the connector and pull outwards.
Lift the screen from the frame at the top of the laptop.
At the bottom of the screen, there will be a cable connected to the body of the laptop. Remove this cable.
On the back of the screen, there will be a ribbon cable that connects to it. Remove this cable by pinching the two tabs on the ends of the connector and pull outwards.
Step 6
- The screen is being held in place by eight screws on the left and right side. Remove these eight screws with a Phillips #00 screwdriver.
- These screws are the only thing holding the screen in place. Make sure you are holding the screen when you are removing the last few screws.
- Remove the screen.
The screen is being held in place by eight screws on the left and right side. Remove these eight screws with a Phillips #00 screwdriver.
These screws are the only thing holding the screen in place. Make sure you are holding the screen when you are removing the last few screws.
Remove the screen.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Raymond Kwasneski
Member since: 01/30/2020
484 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
Embry-Riddle Aeronautical University, Team S14-G6, Lamothe Spring 2020
Member of Embry-Riddle Aeronautical University, Team S14-G6, Lamothe Spring 2020
ERAU-LAMOTHE-S20S14G6
3 Members
5 Guides authored