Difficulty
Moderate
Steps
3
Time Required
15 minutes
Sections
1
- RAM
- 3 steps
Flags
0
BackHP EliteBook x360 830 G7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RAM
- Turn the computer over so the back is facing up.
- Use a Torx T5 screwdriver to remove the three 9 mm screws from the hinge of the device.
- Use a Torx T5 screwdriver to remove the two 7 mm screws from the left and right mid-section of the case.
- Lift the backplate from the computer.
Turn the computer over so the back is facing up.
Use a Torx T5 screwdriver to remove the three 9 mm screws from the hinge of the device.
Use a Torx T5 screwdriver to remove the two 7 mm screws from the left and right mid-section of the case.
Lift the backplate from the computer.
1024
Step 2
- Gently lift the larger rectangular metal RAM shielding off.
Gently lift the larger rectangular metal RAM shielding off.
Step 3
- Push down on the two latches on either side of the ram to release the device
- This will allow you to remove the device. and replace it with no issues.
Push down on the two latches on either side of the ram to release the device
This will allow you to remove the device. and replace it with no issues.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Abigail Herring
Member since: 03/21/2022
165 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
University of Alabama, Team 2-1, Bedsole Spring 2022
Member of University of Alabama, Team 2-1, Bedsole Spring 2022
UA-BEDSOLE-S22S2G1
4 Members
5 Guides authored