Difficulty

Moderate

Steps

6

Time Required

                          3 - 5 minutes

Sections

3

  • Removing the Back Cover
  • 1 step
  • Removing Stand
  • 3 steps
  • Fan Assembly
  • 2 steps

Flags

0

  • BackHP EliteOne 800 G1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Removing the Back Cover
  • Place computer with the screen down on a flat surface.
  • Push the two locking latches to the unlocked position.
  • Push the cover toward the top of the computer and lift up.

Place computer with the screen down on a flat surface.

Push the two locking latches to the unlocked position.

Push the cover toward the top of the computer and lift up.

1024

Step 2

              Removing Stand
  • Press locking latch on the bottom of the base of the stand.
  • Pull the plastic cover off of the stand.

Press locking latch on the bottom of the base of the stand.

Pull the plastic cover off of the stand.

Step 3

  • Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.
  • Tilt stand and lift up to remove it.

Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.

Tilt stand and lift up to remove it.

Step 4

  • Use a Torx T15 driver to remove the single 10mm screw on the back panel.
  • Pull the back panel toward the bottom of the device to remove it.

Use a Torx T15 driver to remove the single 10mm screw on the back panel.

Pull the back panel toward the bottom of the device to remove it.

Step 5

              Fan Assembly
  • Disconnect these two power connectors on the motherboard, one connector is white and the other is black. You can identify the correct wires by their braided colors: red, yellow, blue, and black.

Disconnect these two power connectors on the motherboard, one connector is white and the other is black. You can identify the correct wires by their braided colors: red, yellow, blue, and black.

Step 6

  • Use a Torx T15 driver to remove the three 6mm screws surrounding the fan assembly.
  • Pull the fan assembly up from the case to remove it.

Use a Torx T15 driver to remove the three 6mm screws surrounding the fan assembly.

Pull the fan assembly up from the case to remove it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 4 other contributors 


                    Michael Ewing

Member since: 10/01/2015

980 Reputation

                                      4 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team 1-24, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 1-24, Maness Fall 2015 



                    CPSU-MANESS-F15S1G24                     


                                            4 Members                     


                                            14 Guides authored