Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

2

  • HP Envy 15-u001dx Disassembly
  • 5 steps
  • Cooling Fan
  • 2 steps

Flags

1

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

  • BackHP ENVY x360 15-U Series

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              HP Envy 15-u001dx Disassembly
  • Remove the two no-slip covers on the rear, bottom side using spudger shown in top center of picture.
  • The two in the front do not have to be removed as there are no screws underneath them.

Remove the two no-slip covers on the rear, bottom side using spudger shown in top center of picture.

The two in the front do not have to be removed as there are no screws underneath them.

1024

Step 2

  • Remove the two cover tabs towards center of the bottom as there are screws underneath them.

Remove the two cover tabs towards center of the bottom as there are screws underneath them.

Step 3

  • Remove all fourteen 4.5 mm screws from the bottom using a Phillips #0 screwdriver. Each location is marked by a red circle in the picture.

Remove all fourteen 4.5 mm screws from the bottom using a Phillips #0 screwdriver. Each location is marked by a red circle in the picture.

Step 4

  • Separate the top cover by using a spudger to go around the sides freeing the inside latches.
  • Once the bottom is free, carefully open to the inside as there are two ribbons that connect your keyboard and touch pad to the top cover.

Separate the top cover by using a spudger to go around the sides freeing the inside latches.

Once the bottom is free, carefully open to the inside as there are two ribbons that connect your keyboard and touch pad to the top cover.

Step 5

  • Use the spudger to detach the two ribbons from their connectors.
  • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Use the spudger to detach the two ribbons from their connectors.

The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Step 6

              Cooling Fan
  • Remove the three 4.5 mm Phillips #0 screws holding the fan in place.

Remove the three 4.5 mm Phillips #0 screws holding the fan in place.

Step 7

  • Gently detach the connector with a spudger and the fan is free to be removed.
  • The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Gently detach the connector with a spudger and the fan is free to be removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 3 other contributors 


                    Dakota Presley

Member since: 10/05/2016

885 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 9-4, Lacy Fall 2016                        

                                                  Member of USF Tampa, Team 9-4, Lacy Fall 2016 



                    USFT-LACY-F16S9G4                     


                                            4 Members                     


                                            7 Guides authored